PSC01

Powerflash Security Interface Module

Allows almost anything to send X10 signals! Dry contact or low voltage (6-18VDC) activates X10 signal

The PowerFlash Interface sends an X10 signal in resonse to a motion detector, photocell, magnetic window switch, you name it! If it's got output, it can probably trigger the PowerFlash. The module can be activated by a low voltage (6-18VDC) or a dry contact (no voltage) switch closure. Once activated, the module sends an X10 signal. The module becomes deactivated when the low voltage is removed or the dry contact switch is opened.

Use as a burglar alarm interface! Wire the output from your existing security system to this module. When your alarm trips, the PowerFlash Module can cause your indoor and outdoor X10 lights to flash! This not only scares your intruder but also makes your intruded house quickly visible to others in emergency. Use the PowerFlash Module with any input to activate a chime or siren.

PSC01 Manual

$0.00
Was $29.72
Saving: $29.72

Tell a Friend about this product

Back to products page.